We use cookies to ensure optimal usability of our website. By continuing to use the website, you agree to the use of cookies. Further information can also be found in our privacy policy. Accept cookies
Please enable cookies in your browser for this website.

CANoe/CANalyzer Option .Scope

Integrated oscilloscope solution for CANoe and CANalyzer

The Option .Scope* is an integrated oscilloscope solution for CANoe and CANalyzer based on an USB oscilloscope hardware. The supported hardware has up to 4 input channels for 2 CAN/CAN FD/FlexRay or 4 LIN/IO and is triggered using the sync line of Vector´s interface hardware. With busspecific trigger conditions and the CANoe/CANalyzer time synchronization, you can find the cause of protocol errors much faster than with any traditional oscilloscope.

*CANscope successor product

news



Product highlights:

  • Bus-specific trigger conditions for CAN, CAN FD, FlexRay and LIN
  • Trigger modes: single and repeat
  • Trigger and control via CAPL
  • Complete decode of protocol errors (e.g. CAN Error Frames)

Applications:

  • Bit-accurate analysis of bus protocol errors
  • Validation and debugging of conformance tests
  • Check of CAN signal quality
  • Parallel evaluation of bus and I/O signals

Integration in CANoe/CANalyzer

The option .Scope appears in CANoe and CANalyzer as a new Analysis Window with views for configuration, data capture, Diagram Window and Trace Window. Diagram and trace are bi-directionally synchronized with each other and provide a bit-accurate signal decode. The Oscilloscope window can also be synchronized with other analysis windows in CANoe/CANalyzer such as Trace, Graphics and State Tracker. Oscilloscope measurements can be exported and imported again for off-line analysis.

Integration in CANoe/CANalyzer

Oscilloscope Hardware

  • USB precision oscilloscope PicoScope 5444B-034
  • 500 MS/s sampling rate and 512 MS buffer
  • 4 input channels for bus signals (2 CAN/CAN FD/FlexRay or 4 LIN/IO)
  • Bus connection via Vector „Scope Bus Probe“ with DSUB connector
  • 1 input for external triggering via sync line of Vector interfaces
  • Connection to Vector interfaces via Scope Trigger Cable
Oscilloscope Hardware

 

Did you find this page helpful?
E-Mail:

Please comment: